![]() You can be down a fingers width of coolant in that tank and it will sometimes trigger the light.Īdd a bit more 50/50 cooling water mix if your level is not significantly low and you are not losing coolant. even the new aftermarket ones are very sensitive and I think they are designed to be that way. I believe the switch in the Saturn coolant reservoir is a pressure switch as it is all the way at the bottom and must conceivably work off of the head pressure of the liquid above it. I assume this is when the coolant warms up a bit and expands, raising the level in the expansion tank. They flash for about two minutes while I'm driving, then stop. One way to test whether your level needs to be topped off a little higher than recommended is to fill the container above the fill level with water and observe over the next few days. ![]() Its just a level sensor and not a way to detect dirty coolant. I think that is when the thermostat opens and some of the fluid from the expansion tank gets into the system, dropping that level ever so slightly. Re: 03 元00 low coolant level light on intermitently level is fine. There are the instruction's for changing the coolant and the thermostat with diagram's.If you have never replaced the coolant cap i would change that too.This happens on both my 95 and 97 SC2 at cold startup. Tighten the bolt to 10 Nm (18 inch lbs.). Install the bolt that secures the water pump feed pipe. Install the feed pipe that connects the thermostat housing to the water pump. 1) new tank (and thus sensor) 2) remove tank and clean out really really well to unstick the sensor. Important: Lubricate the O-ring with soapy water or coolant before installing the O-ring in the water pump. Install the thermostat and retaining sleeve with the dimple placed into the housing slot. Remove the thermostat and retaining sleeve, noting the orientation for installation. Remove the bolts that secure the thermostat housing to the water pump feed pipe. Rinse away any excess coolant from the engine and the engine compartment. Run the engine at 2,000-2,500 RPM for 3 minutes. Slowly add a mixture of 50/50 DEX-COOL antifreeze and deionized water to the cooling system until the coolant level reaches and maintains slightly above the cold fill line on the surge tank. Ive had my 'low coolant' light on my dash, almost constantly, turned on for about 5 days. It is necessary to maintain the coolant level near the cold fill line on the surge tank to insure all the air has been purged from the cooling system. Important: Use a 50/50 mixture of DEX-COOL antifreeze and clean, drinkable water. Gas Fuel Diesel Caddy Transfer Tank 30 Gal Container With Rotary Pump 8 FT Hose. Pontiac Solstice Coolant Reservoir 2006-2010. ![]() Tighten the plug to 22 Nm (16 inch lbs.). Radiator Coolant Overflow Bottle Reservoir Tank W/Cap For Saturn Pontiac 603-097 eBay. as far as the temp reading high, its also a known issue and ive attached a couple of Technical Service Bulletins that will need to be complies with. Replacing the coolant leveL sensor usually takes care of the issue. Hello, circuit testing is all I can recommend. ( Rock Auto has em for 60 or so, plus shipping and a bottle of coolant, expect about 75. have already changed coolant bottle with sensor and connector. ( Less annoying, almost free, still have to check coolant from time to time. The low coolant light is a common problem on Saturns. Check your own coolant level from time to time) wire the sensor wires together. Install the water pump drain plug (1) if removed during the draining process. Hi Im David, thanks for visiting the site. Notice: Refer to Fastener Notice in Service Precautions. coolant during the first five years of operation AECL - 3085 ALLISON. Drain your engine reservoir and that light. Empty, as in adding about 1/2 gallon each time and never got a coolant light. I ran my car with no coolant in the intercooler when my cores were leaking several times. Plus, that light is for low coolant, not coolant system performance. Improper coolant level could result in a low or high coolant level condition, causing engine damage. Light observation helicopter avionics package Final report, 21 Jan. Mine didnt and the pump was totally inop. Notice: The procedure below must be followed. Normal in appearance - follow the filling procedure. Inspect the appearance of the engine coolant for discoloration: If a complete block drain is required, place a drain pan under the water pump drain. Place a drain pan under the right side lower radiator mount. The cooling system will release scalding fluid and steam under pressure if radiator cap or surge tank cap is removed while the engine and radiator are still hot. Caution: To avoid being burned, do not remove the radiator cap or surge tank cap while the engine is hot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |